Hi All. New guy here. Not new to molding, just the forum.
I have an 1986 Nissei 360 with the NC-8000 control [yes, I know ancient]
It has been sitting in the shop for several years & I just got around to starting it up. I got a mold in & was making parts [about 20] when it shut off.
The book says 101 is check input power which I did, all good 487-488V, I even checked the control transformers & power supply to the control.
I cannot reset that alarm even after resetting the control [says OK] it goes back into the alarm mode as soon as I turn the control on?

One more thing as this is my first Nissei. Should I be able to rotate the motor/pump by hand?