-
14th January 2018, 12:29 AM
#1
Re: Newbie question re: Multi-coloured injection moulding of silicone/ rubber material
Did I commit a faux pas due to lack of process knowledge? Even if I'm way off the mark, I'd really appreciate a heads-up to that effect...
-
15th January 2018, 09:00 PM
#2
Re: Newbie question re: Multi-coloured injection moulding of silicone/ rubber material
The only way I could think to do that would be a 2 shot method or overmolding. I haven't had much experience with that other than doing some over molding of parts. Might be doable, but can it be painted instead? might be easier.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules