Results 1 to 8 of 8

Thread: Two piece nozzles

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 15th February 2017, 09:31 AM #1
    tbramel
    tbramel is offline Member
    Join Date
    Apr 2012
    Location
    Changshu, Jiangsu, China
    Posts
    31

    Two piece nozzles

    We are currently in the process of changing out our one piece nozzles with two piece nozzles. I was wondering if there is a standard tolerance for mismatch between the nozzle body flow channel and the nozzle tip flow channel? If not any suggestions?
    Reply With Quote Reply With Quote
  2. 17th February 2017, 01:10 PM #2
    rickbatey's Avatar
    rickbatey
    rickbatey is offline Senior Member
    Join Date
    Aug 2011
    Location
    Upstate of South Carolina
    Posts
    701

    Re: Two piece nozzles

    Order full internal taper to eliminate dead spots in resin flow.
    Rick.
    Reply With Quote Reply With Quote
  3. 17th February 2017, 07:29 PM #3
    Suhas
    Suhas is offline Forum Administrator
    Join Date
    Aug 2011
    Posts
    625

    Re: Two piece nozzles

    Listen to Rick
    Suhas
    Reply With Quote Reply With Quote
  4. 21st February 2017, 04:09 PM #4
    brentb
    brentb is offline Senior Member
    Join Date
    Aug 2011
    Posts
    541

    Re: Two piece nozzles

    Are you doing this for flexibility/cost/ease of change? By "two piece" do you mean replaceable tip(RT) nozzles?



    KOM

    brent
    Reply With Quote Reply With Quote
  5. 22nd February 2017, 09:28 AM #5
    tbramel
    tbramel is offline Member
    Join Date
    Apr 2012
    Location
    Changshu, Jiangsu, China
    Posts
    31

    Re: Two piece nozzles

    brentb,

    Doing this mostly for ease of change. And yes I am referring to replaceable tip nozzles.
    Reply With Quote Reply With Quote
  6. 22nd February 2017, 02:31 PM #6
    brentb
    brentb is offline Senior Member
    Join Date
    Aug 2011
    Posts
    541

    Re: Two piece nozzles

    In this case, this is one of a few times that you shouldn't" listen" to Rick nor to Suhas

    PPE, IMS and Molder's Choice, all sell RT components. I am not aware of tolerances on mismatch, but never have had a problem, including medical resins like PL24.

    MC has "E" tips for even greater flexibility. I use RT tips on most all jobs, for listed reasons.

    You could contact a supplier for info of any existing tolerances.

    KOM

    brent
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules