-
11th February 2017, 04:41 PM
#1
Engel cc300 question
Hello all,
My company has just purchased a new Engel machine and it has the cc300 control panel.
My question: I want to set the machine to have no back pressure when in manual. This option can be found in the variable monitor page, but when I activate it, I get no option under the plasticizing page for manual back pressure as I should.
I'm hoping someone with some knowledge can tell me why this option doesn't appear on the plasticizing page. Is there something I am missing once I activate it?
Any insight is greatly appreciated. Thanks.
-
12th February 2017, 01:03 AM
#2
Re: Engel cc300 question
Ok you don't need to do that. I think if you leave the parameters alone and just press the SIT deadman button when the auto-recover runs, there will be no back pressure.
Rick.
-
12th February 2017, 07:00 PM
#3
Re: Engel cc300 question
I Agree with Rick,
We've been using the Deadman buttons for years when building a shot and purging. on both our CC200 and CC300 controllers.
-
13th February 2017, 11:48 PM
#4
Re: Engel cc300 question
Thank you gentlemen, this was a much easier solution.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules