Results 1 to 4 of 4

Thread: Nautilus Software Question

  1. 23rd February 2012, 04:21 AM #1
    brentb
    brentb is offline Senior Member
    Join Date
    Aug 2011
    Posts
    541

    Nautilus Software Question

    When using your new Nautilus Software, and doing the viscosity curve portion of the 6 step validation process, what does one enter for intensification ratio if the press is electric? 0? 1?


    Keep on molding!

    brent
    Reply With Quote Reply With Quote
  2. 23rd February 2012, 02:12 PM #2
    pjhall
    pjhall is offline Member
    Join Date
    Aug 2011
    Location
    Santa Rosa, CA
    Posts
    95
    We have a couple of niigata electrics and the pressures are already in plastic pressure. max 27,000 on one and 31,000 psi on the other. I suppose you could divide by 10 and put this number as the hydraulic pressure and then put an intesification ratio of 10 .
    Reply With Quote Reply With Quote
  3. 23rd February 2012, 03:43 PM #3
    Suhas
    Suhas is offline Forum Administrator
    Join Date
    Aug 2011
    Posts
    625
    Brent, The intensification ratio for electrics would be 1. The formula is Viscosity = Pk Pressure X Fill Time X IR. So IR cannot be zero.
    PJ, In the software you can put plastic pressure or Hyd. I have both options.
    Suhas
    Reply With Quote Reply With Quote
  4. 24th February 2012, 02:54 AM #4
    brentb
    brentb is offline Senior Member
    Join Date
    Aug 2011
    Posts
    541
    Yup, the data at zero didn't look very logical at all!!!

    Keep on Molding!

    brent
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules