Insulation plates

[3NGLENN1889]

Thanks Suhas for the reply. I spoke with my engineers and maint guy to see what we can do, exactly as you mentioned. It's a start, so... we'll see. Have a good day. I'll post any relevant information or interesting findings if we get anywhere. G.P.

[Brisli]

I know this is slightly off topic, but we had to remove our insulator plates due to flatness issues, we were molding lenses for cell phone cameras with a total tolerance of 10 millionths of an inch on the spheres. instead we ground a cross hatch pattern on the mounting plates to reduce the surface area for heat xfer. not as effective but you do what you have to do.

Brian