-
4th October 2021, 09:23 PM
#1
Re: Getting ready to test
Carriage, screw & injection rams:
Attachment 560
Rear of machine:
Attachment 561
BTW: in the pictures of the barrel and screw/carriage the guards have been removed temporarily.
So, my main questions:
1) Do I have the injection sequence correct (first post above)?
2) Website where I can learn about how to do this correctly?
3) Barrel temps for ABS?
4) Suggested settings on "injection screen" for ABS?
5) Back Pressure for ABS?
6) Injection pressure for ABS?
7) How do I start slow on a given mold and increase the shot size, etc. until I have enough (cavity filled) but not too much (straining anything/wasting time/causing excessive ware)
8) Any other info, suggestions, websites, etc. for a newbie?
Again, any guidance much appreciated.
BTW: This is a video of my current ram-type molder making my parts: https://youtu.be/EyxlcS9tGkM
Regards,
Chuck
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules