-
1st September 2021, 02:15 PM
#1
Ejector Pin Lubrication
What is the best non-bleeding lubrication for molds that run up to 180°F. I'm working toward converting to greaseless pins, but need an interim solution. Also, has anyone taken existing ejector pins and had them coated to eliminate the need for grease. If so what works the best?
-
1st September 2021, 10:50 PM
#2
Re: Ejector Pin Lubrication
hi Joe
we use up to 400F
RENOLIT ST-80
Lithium 12-Hydroxy High Performance Grease
some molds also :
Krytox™ XHT (Extreme High-Temperature) Greases and Oils
BR
-
3rd September 2021, 12:48 PM
#3
Re: Ejector Pin Lubrication
I recommend using progressive components black nitride components.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules