-
12th May 2021, 10:24 PM
#1
Hot-Runner/Mold Cable Configuration Standard
Hi All,
Anyone know of a known ISO, ASTM or some other standard for Hot-Runner/Mold Cable configuration?
We have an internal standard generally 24 pin 12 zone Han B connections, keeping power and thermocouple cables separate. Then double latch mainframe side and single latch mold side.
Been searching for a bit and haven't found much for general standards, everyone does it a little differently. Thought I'd start a thread here for discussion
Any ideas?
Thanks,
Chris
-
21st May 2021, 03:43 AM
#2
Re: Hot-Runner/Mold Cable Configuration Standard
I would look through the DME catalog, i can't seem to link the catalog on here, but it list all the configurations i have seen.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules