Hello gang,

Wanna poll all you guys here, because I am not the expert with mold flows:

I am being asked to approve a gate design based upon a mold flow analysis, and I don't know how accurate these are typically.

For instance, if the mold flow ( Autodesk Moldflow Insight 2019 was used) the max plastic pressure stated was 15,000 psi.... Is this good plus/minus 10%?

And if it states max deformation is 0.4mm, is this good to plus/minus 10% as well?

Last question, (not as important to understand), it shows a fill time of 3 seconds, would this be an input by the guy doing the mold flow?

Thank You!
Joel