-
7th December 2020, 08:57 AM
#1
Family Mold
Hi everyone
ı need your advices.
we will make a family mold and this will be the first.
could you share some info. about family molds? (What should be runner dia. and length or any info about family mold)
good work to everyone
-
7th December 2020, 05:09 PM
#2
Re: Family Mold
hello, the family tool must be properly balanced, especialy when you can use a cold runner with one injection gate. You can use also cascase hot runner, where you will be able to control filling.
Is hard to answer your question. It depends on parts size, how many cavities, material, cycle time......
-
16th December 2020, 12:57 PM
#3
Re: Family Mold
I have developed a family mold with 5 dissimilar cavities. The mold used sequential valve gates and my process was predicted based on simulation from RJG Inc.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules