-
17th October 2020, 12:02 PM
#6
Re: Design for PIM, maximum thickness strictness?
Depends a lot on part shape and gating strategy. Our sprues are often .250" or .375" diameter and mold just fine. But I wouldn't expect to get good results gating into one end of a "flat bar" or "bath tub" shaped part that thick. Certainly the .125" figure mentioned is not a hard limit. We routinely go thicker than that in ABS, PS, PC, ASA.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules