-
21st August 2019, 03:00 PM
#15
Re: Ultem and CF Peek in an aluminum mold
Unfortunately that is the exact shape and size of the part, only that there are two cavities in the mold. One facing up, the other upside down. Nearly in the shape of a square.
As for the runner and sprue - sprue starts at .275 and opens / tapers to the runner at .400
The runner is circular - undersized at .370 (I say undersized because typical runners are 75% of the part wall thickness - usually)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules