Hi all!
I have been troubleshooting a 96 cavity valve gate hot runner tube mold and have become a little confused on the functions of the mold gate (which I am assuming is the valve gate).
In my attachment, the sequence selection selected is Clp Pos Cls After Inj is enabled and Open 3.00 inches. The allow time is 0.40 seconds and I'm not sure what is actually going on.
The user manual is not very clear to me, and the sequence selection chosen is not explained. I have attached screen shots of the manual.
Hopefully one of you can explain what my machine settings are doing and recommend a change if necessary.