-
21st January 2019, 08:05 PM
#3
Re: Calculation Method for Clamping Force needed
I'll generally use 3 - 5 tons per square inch of molded plastic at parting line
Slightly higher if slides are used
Ultimately the molded part itself will tell you where tonnage should be - ie run a little faster injection speed/holding pressure as a 'worst case scenario' and just keep coming down on tonnage until you start to see little flash in areas
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules