Results 1 to 4 of 4

Thread: Arburg 305 info

  1. #1

    Arburg 305 info

    Hi,

    I've recently acquired two arburg 305's with polytronica controls and a selection of mould tools.

    Unfortunately when removed from their previous site, the wiring for the controls was just cut.

    Does anyone have wiring diagrams for these machines so I can make good the damage and test run the machines.

    I also have a complete 221 with the same control. Would this be the same electrically?

    Many thanks in advance.

  2. #2
    Join Date
    Dec 2012
    Location
    Serbia
    Posts
    107

    Re: Arburg 305 info

    Hi,

    I worked with few models with selogica controls, and all have same system in electrical cabinet. Should be same for all other machines.
    Regards,

  3. #3
    Join Date
    Oct 2016
    Location
    McMinnville, OR
    Posts
    172

    Re: Arburg 305 info

    I have only worked with the Selogica controls as well. Arburg tends to make them close to the same in that range. However I haven't worked with a polytronica. Arburg service is usually pretty helpful. Have you called them to see if they could get you a set of drawings?

  4. #4

    Re: Arburg 305 info

    As stated Arburg offer very good support, even for older machines. Roger Cox is the contact I use and find him to be excellent.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •