-
18th July 2018, 02:43 PM
#6
Re: Living hinge advice
Hello!
If the part is too long, try reduce cooling time. i had same problem on similar tool, and i had to reduce cycle time for almost half, from 50s to 33 s. open the mold as soon it is possible, so the part start shrinking when its hot. And reduce holding pressure time, but you will have biger sink marks, i dont know how much it is aceptable. Boris
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules