Results 1 to 4 of 4

Thread: Procerex with Mold Vac System

  1. 8th March 2021, 05:43 PM #1
    joeprocess
    joeprocess is offline Senior Member
    Join Date
    Sep 2012
    Location
    Indianapolis, IN
    Posts
    114

    Procerex with Mold Vac System

    Anyone have success using Procerex with MoldVac to improve the appearance of weld/meld-lines? Material is gray Valox 357 (FR) Problem is not so much a visual weld line as it is discoloration from where the flow fronts meet.
    Reply With Quote Reply With Quote
  2. 9th March 2021, 01:51 PM #2
    JayDub
    JayDub is offline Senior Member
    Join Date
    Aug 2014
    Location
    Saint Paul, MN
    Posts
    181

    Re: Procerex with Mold Vac System

    I have not used Procerax for this purpose, but I have worked with tools that had inserts just to provide venting at the knit line to improve appearance. Of course, you trade discoloration for a witness line, but I imagine that will be even worse with Procerax.
    Reply With Quote Reply With Quote
  3. 10th March 2021, 12:05 AM #3
    Suhas
    Suhas is offline Forum Administrator
    Join Date
    Aug 2011
    Posts
    625

    Re: Procerex with Mold Vac System

    Yes, this works good but you will not a smooth finish in that area.
    Suhas
    Reply With Quote Reply With Quote
  4. 10th March 2021, 02:54 PM #4
    joeprocess
    joeprocess is offline Senior Member
    Join Date
    Sep 2012
    Location
    Indianapolis, IN
    Posts
    114

    Re: Procerex with Mold Vac System

    Yes, I'm aware of the surface differences, not sure if the customer will like it, but something has to be compromised. The inserts would be visible, but not on an outer surface.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules