-
17th April 2017, 08:16 AM
#1
Flow marks in Moldflow .
Hello ,
Can we see the flow marks in moldflow simulation . If no then how to predict Flow marks by using Moldflow?
Please share your views on this .
-
18th April 2017, 01:59 AM
#2
Re: Flow marks in Moldflow .
Mandar I've always seen knit lines in the Moldflows since joining automotive but it's more than likely an option they changed they charge a premium for. Just remember that it's a simulation and at times it's very accurate while others not so much.
Rick.
-
18th April 2017, 01:32 PM
#3
Re: Flow marks in Moldflow .
Thank you so much Rick for ur reply.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules