-
13th September 2020, 07:36 PM
#1
Velocity-Pressure-Time Parameters
ı use moldflow for analysis but there's some points that ı cant understand
For fill analysis ı can use just one parameter(like ınjection time)
However while ı am entering some values to ınjection machine, it wants velocity,pressure and ınjection time.
If ı control fill analysis with ınjection time , appears some results in moldflow.
Example; according to results that from moldflow, ıf ı keep ınjection time 3sn , ı need 30 mpa ınjection pressure and max velocity 107 cm3/s.
should ı use this results while ı entering values to ınjection machine ı?
If ı keep constant a parameter except ınjection time(example max pressure) and ı reduce or increase what would happen?(ı ask this because ı cant do that with moldflow. Software let just one parameter that ı can control fill stage.)
sorry for my english
thanks your answers
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules