-
15th February 2017, 09:31 AM
#1
Two piece nozzles
We are currently in the process of changing out our one piece nozzles with two piece nozzles. I was wondering if there is a standard tolerance for mismatch between the nozzle body flow channel and the nozzle tip flow channel? If not any suggestions?
-
17th February 2017, 01:10 PM
#2
Re: Two piece nozzles
Order full internal taper to eliminate dead spots in resin flow.
Rick.
-
17th February 2017, 07:29 PM
#3
Re: Two piece nozzles
Listen to Rick
Suhas
-
21st February 2017, 04:09 PM
#4
Re: Two piece nozzles
Are you doing this for flexibility/cost/ease of change? By "two piece" do you mean replaceable tip(RT) nozzles?
KOM
brent
-
22nd February 2017, 09:28 AM
#5
Re: Two piece nozzles
brentb,
Doing this mostly for ease of change. And yes I am referring to replaceable tip nozzles.
-
22nd February 2017, 02:31 PM
#6
Re: Two piece nozzles
In this case, this is one of a few times that you shouldn't" listen" to Rick nor to Suhas
PPE, IMS and Molder's Choice, all sell RT components. I am not aware of tolerances on mismatch, but never have had a problem, including medical resins like PL24.
MC has "E" tips for even greater flexibility. I use RT tips on most all jobs, for listed reasons.
You could contact a supplier for info of any existing tolerances.
KOM
brent
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules