I agree with Jendalf, could be a problem with the surface temperature in the mould. Also check that you have a melt cushion during injection holding phase or that the holding pressure time is not too...
Type: Posts; User: Squirter; Keyword(s):
I agree with Jendalf, could be a problem with the surface temperature in the mould. Also check that you have a melt cushion during injection holding phase or that the holding pressure time is not too...
I have run this material before. In my situation we fitted a plate with a feed throat orifice underneath the hopper slider. The plate had a small hole drilled horizontally in it from the outside into...
One thing to consider, if there is a possibility of running heat sensitive materials in the future e.g.POM, I would recommend having a removeable jacket section at the front of the barrel over the...
This is the advice I used to give to technicians who were having issues with foaming agents, based on my own experience:
INJECTION MOLDING WITH FOAMING AGENTS
Foaming agents are used with...
Check the weight of your part is not heavier than your sample