Search:

Type: Posts; User: Platt1990; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    315

    Re: Overmold Possibility

    I would say most of this is right in overmoulding I have always had a section exposed normally that is also used for sleeves or bolts. But maybe (and doubtful it will work) use two core pins near the...
  2. Replies
    14
    Views
    240

    Re: Designing a low energy plastic "chopper"

    There probably is but none that I’m aware of that wouldn’t bridge the feed throat. Maybe something in blow molding or extrusion can use it.
  3. Re: Electrical fault: Cycle stops midway through

    My question is about the barrel forward position. Is it a set point by inch.(mm,cm,etc.etc.) or hydraulic pressure. If it doesn’t see it’s zero point it will cycle through to injection and stop...
  4. Replies
    14
    Views
    1,447

    Re: Liquid color issue

    If it had dark to light spots in both types of colorant my next question is does it have deep ribs or small or thin wall flow areas across the parts if so shooting slower or raising mold (steel)...
  5. Replies
    14
    Views
    240

    Re: Designing a low energy plastic "chopper"

    Mainly what is meant by that would be clogging issues near the feed throat witch can cause a “bridge” problem. I would be more worried about melting problems. If the squares are to thick it could...
  6. Re: 150i robo shot won’t go into semi-auto

    I ended up getting ahold of a press maintenance buddy of mine. It seems that after they had replaced the door switches on day shift the back door switch roller arm was not put in the proper position...
  7. 150i robo shot won’t go into semi-auto

    After checking the press over mechanically it seems fine I checked the currents fuses and delinked all secondary equipment but it won’t go into semi so I can’t get to auto according to the I/o...
Results 1 to 7 of 7