Hi,
Generally speaking the mold / machine combination is determined by the tonnage needed to make your part. The smaller mold is just not running as efficiently from a machine hour cost basis in...
Type: Posts; User: Oldbob; Keyword(s):
Hi,
Generally speaking the mold / machine combination is determined by the tonnage needed to make your part. The smaller mold is just not running as efficiently from a machine hour cost basis in...
Looks like they might be pushing their material too fast, so you are not getting a smooth flow at sight 1. Since you are probably not going to get much cooperation from them as long as their material...
Hi Curious,
Without observing the entire process, I could not hazard a guess as to how accurate those holding pressures are. Generally speaking you should have done a cycle optimization when you...
Unfortunately Nylon is a hygroscopic material. It will dry out and become brittle. In the past I have worked at places where we had to add water to the parts just before shipping so this would not...
Actually the injection unit is run by a servo, so no hydraulic to the injection unit, just the screw rotation gear box. Are you thinking a possible short in the line on the Transducer? Or should i be...
We have an Arburg Allrounder 570A 175 ton hybrid (electric / Hydraulic). Injection pressure was not reading what it normally was. Replaced the force sensor, boards and modules.
Currently it will...
When the mold was designed did you calculate the brass shrinkage due to heat (considering that PEEK has a melt index approx. 360C). If it is a cylinder the ID will actually get smaller as it heats...