Search:

Our factory bought a new ferromatik milacron Hydron servo 150 IMM. Already we have Hydron 150.new machine has a servo motor behalf of old induction motor.Servo motor system can give accurate pressure...

Thank
As I think,double acting method is better than spring return.Because,spring return can be stuck in material.
Anyway,Is valve gate usage only for make clear surface part without gate point(End...

Thanks
Is hotrunner pin cylinder double active?

Hi Friends,

I have seen an air supply to the fix half of mold.and it has hot runner system.
sometime,If material is dirty(mixed nonferrous metals),cavity gate is stuck. In that time technician...

Thank you both of you.
How work air eject system?
I have seen air supply to the stationary plate of mold.but,part ejecting from moving plate.So,How help to eject the part using air eject?:confused:...

Hi all,

What is air eject in IMM?

yes.Electronica is the brand name.220 is the maximum tonnage of IMM.

yes,I know.injection phase can optimize for several steps.called as profile..
According to your explanation,we should fill 85-95% quickly in injection phase using profiles or using one step.
What...

Hi,
I haven't fully understand about injection molding cycle steps.I'm trying to understand it.
Is Pack and hold one or two step?
I have read about IMM cycle. Accordion to that,Pack and hold step...

Thanks Rick.I forgot feed throat.
Where can I find user manual,electrical diagram for Endura220?

Hi friends,

We have a Endura 220 IMM.It has 5 heating zones.
Zone1,2,3,4,Zone5 and Spare .Zone5 named as B.T.and it has Spare zone also.
What are this B.T. Zone and spare?

Fallowing photo is...

thanks Scott.

Thanks both of you.I'm very happy about your answer.I'm trying to understand about IMMs.
I got an idea about jam bar.
I have seen a jam bar in Ferromatik Milacron-Omega 150 IMM.
Its like this, ...

Hi all,
I have read about injection molding machine problems.there was a reason for bubbles,Back pressure too low.What is the back pressure?
thank

Hi Friend,
What is JAM Bar in injection molding machine?

Thank

Thanks for answer.
What are reasons for keep pressure out of the tip of the barrel?
according to my experience there are two suck back steps.one for screw at the front. another one screw at the...

Hi Friends,
I'm a beginner for injection molding machine(plastic).Now I'm working in a factory that has several plastic injection molding machine.
I haven't fully awareness about molding machine...