Search:

Type: Posts; User: Xpump; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    148

    Re: milacron maxima 580wp issue

    what is the year of the machine?
  2. Replies
    6
    Views
    194

    Re: Van Dorn 300HT excessive noise

    Hello, Did you check the suction filter in the tank? If its dirty you will cavitate pumps on any demand.
  3. Re: Cincinnatti Milacron: Looking for motherboard

    what is the model and serial number of machine?
  4. Re: Cincinnati/Milacron: Opinions on presses & service

    much better now, quality is better and so is service department
  5. Re: High Oil temperatuer reading on Injection molding BOY

    does the pump shut off on over limit of oil temp?
  6. Replies
    1
    Views
    165

    Re: milacron vs nissei

    Milacron, Much better machine and Tech support. Been a Maint Tech in Injection molding for 24years.
  7. Replies
    3
    Views
    2,769

    Re: Mid 90's nissei problems

    Great to hear, hope this solves all your problems. I used to live in Erie, pa and worked at Caplugs Plastics company for 23 years in Maintenance. Moved to Cincinnati 6 months ago for better...
  8. Replies
    3
    Views
    2,769

    Re: Mid 90's nissei problems

    Hello, Been working on this type of machines for 23 years. Make sure your injection barrel is free of material as much as you can purge out, next make sure screw is fully forward,next make sure back...
  9. Replies
    6
    Views
    2,258

    Re: Allrounder 270S 350-170

    Hope all is well with machine Eddie
  10. Replies
    6
    Views
    2,258

    Re: Allrounder 270S 350-170

    I would check your wire connection on motor overloads/contactors first then install new overloads.
  11. Replies
    6
    Views
    5,173

    Re: Creaking noise during injection

    Could be manifold in base making the sounds when fully packed with material and in the holdingstage of injection.
  12. Thread: Check ring,valve

    by Xpump
    Replies
    7
    Views
    3,261

    Re: Check ring,valve

    You can try more screw suck back to seat the check ring
  13. Thread: Check ring,valve

    by Xpump
    Replies
    7
    Views
    3,261

    Re: Check ring,valve

    if you can see the screw turn when it injects that is a good sign that plastic is flowing backwards across flights towards throat, sometimes a bridged throat is a good sign of check ring trouble to.
  14. Thread: Arburg problem

    by Xpump
    Replies
    7
    Views
    8,143

    Re: Arburg problem

    What is your clamp pressure or tonnage at clamp fully locked up. Injection will not happen until this is achieved.
Results 1 to 14 of 14