Search:

Type: Posts; User: collij3; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    2,734

    Re: Van Dorn 300HT excessive noise

    check GG1 valve; cable and card; check kepler valve. Individually probe clamp close valve and clamp open valve while probing high volume valve.
    check clamp and screw press control valve (remove...
  2. Replies
    7
    Views
    3,216

    Re: New Technology For Injection Molding

    1. DFM (design for manufacturing), flow / injection forces contribute to tool damage. premature fatigue, gas venting.
    2. Resin Variables contribute to mold processing and tooling (tolerance, part...
  3. Re: Van Dorn 1000-RS-165-FLP-0395 Clamp Close Issues

    No change same issue
  4. Van Dorn 1000-RS-165-FLP-0395 Clamp Close Issues

    In manual, setup and auto-cycle modes;
    clamp close motion is good until reaches mold protect set point and then clamp stops few seconds then continues to close then stops again and continues to...
Results 1 to 4 of 5