Search:

Type: Posts; User: ChrisGross; Keyword(s):

Search: Search took 0.00 seconds.

  1. ES-43-A8-0609-C-3A Rexroth Valve Driver Board

    Looking for anyone that has had some experience with these Valve Driver Boards. I have 2 presses of the same model number that use this item and we have to spend so much money having them repaired....
  2. Replies
    6
    Views
    4,411

    Re: 250-20 E/P Clamp Close Issue

    So I wanted to leave the fix here in the event someone else runs into this issue.
    The technicians thought it was the pump (so I finally got the chance to pull a pump and rebuild one, super easy as...
  3. Replies
    6
    Views
    4,411

    Re: 250-20 E/P Clamp Close Issue

    So we ended up having to call in some technicians and they believe that the High Volume, fixed displacement pump went bad. We ordered the cartridges and installed them. I'll reply to this message...
  4. Replies
    6
    Views
    4,411

    Re: 250-20 E/P Clamp Close Issue

    Appreciate the reply.

    So I'm checking pressure of the the pump @ TP9 which has a gauge installed. It's one of several rails that will be fed by the V.V. pump according to the schematics and my...
  5. Replies
    6
    Views
    4,411

    250-20 E/P Clamp Close Issue

    Hello all!
    So I have posted before about a clamp issue that we remedied by replacing an output card for the Prefill Close Valve. Today I ask for guidance with another issue. I've already replaced...
  6. Replies
    8
    Views
    15,884

    Re: Old 250 Ton Milacron

    I appreciate everyone weighing in and helping me out. This press was retrofitted to use a PLC instead of its controller. I had preiously checked the electrical portion and found everything to be good...
  7. Replies
    8
    Views
    15,884

    Re: Old 250 Ton Milacron

    Its hydraulic.
  8. Replies
    8
    Views
    15,884

    Old 250 Ton Milacron

    The issue im having is clamp tonnage wont build over 72 tons. I have the press in manual and close the clamp she only makes 72. If i release the clamp close button and depress it again i hear a clunk...
Results 1 to 8 of 10