Search:

Sorry,not sure if this the correct place,if not , please direct me to proper place.
In search of a Camac VLC monitor for a Cincinnatti V220-17 injection molding machine.
Searched on ebay,called...

custom molder and booming,so busy,can't afford to take time off!

Looking for some electrical help. Just installed new/used machine. It boots up,but can't get rid of some errors. Not sure where to start looking. My 24volts is good. Service tech on phone of no...

I believe there are companies that use scrap plastic to make things like park benches. Don't know if it has to be a certain type. That's one avenue to check out.

If service needed, do you call them? How is service?

looking at an injection machine. Has anyone heard of this brand? What are your thoughts? It is a hybrid. Also looking at a Tederic 280. Your thoughts on this as well. Thank you

Hi all,
Looking for a motherboard, part# ES-43-A8-0609-C-3A
Anyone know where I might find one?
Thank you

try swapping out the overload,they do get weaker over time

no sealing ring,thread same,top to bottom. this mold came from either japan or china. trying to find fittings in case one breaks

Hi all.
Looking for male quick disconnect fittings. Looks like your average fitting that you can get anywhere,such as from PPE, part # pn-352,but can"t seem to locate the correct thread. The od is...

T309 is your inj. time, s305 is your switch over point. check to make sure you have a long enough inj. time and as Brent stated, that you reach the switch over position

I lost a heat exchanger. I now have water in my oil and oil in my water. Any suggestions on how to get oil out of tower system or is this something that will eventually clear up. We purge our holding...

Love this site,:D wish I found it years ago. Keep up the great work.

I have a LG Goldstar 610 that does not inject every shot. mold closes,half nuts close, but only reading about 500 psi. disconnected sensor for carriage fwd.now it injecting. also mold closes...

One of my maint. guys figured out to bypass the hyd.safety, then I proceeded to take valve apart and found broken spring. Didn't look broke by actuation of valve,but apparently just enough where...

After all that,I'm kicking myself in the ass! Ended up being a broken spring in the hydraulic safety. Thanks for everyone's help!

Thank you guys,psi at 209 and 107 are reading correctly. 7tr times out and then solenoid is actuated,but there is still delay.checked psi at P104,only reading 600 psi,not reading psi at P105. seams...

Hi Brent,
Not 100% sure on age,guessing mid to late 80's
Vickers/Parker hydraulics
hydraulic clamp
pumps were worn,showed signs of chattering on middle ring on each pump
machine is quiet,don't...

I am stumped! Everything works,but there is a 20-30 second delay before the mold closes,and I don't have fast close. Doesn't matter if man,semi,auto.Took whole clamp manifold apart,checked all...

For LG Goldstar presses,but have a few different machines that also have them. It is for grease.

I try to stay away from Arburg,although they are a good machine,I found you can only get parts from them for the most part. If they are in stock,great. If not,prepare to wait several weeks or months...

Looking for replacement parts for Hals Lube machine mounted manual grease pump. Do they still make it? Can I buy it in the USA?

yes we do use hyd. and air cores. That a good point. Thanks

My company has always had hydraulic machines with toggle or ram. We are looking into purchasing an electric,probably used. Can you guys give us some pros and cons of electric and what manufacturer is...

LG Goldstar, Shinwa, Nissei, Impco, Intertech