HelloŽeveryone
how do you clean hot runners when changing color. I tried everything but still the rejected products number is high.
best regards
Type: Posts; User: MRFARRAN; Keyword(s):
HelloŽeveryone
how do you clean hot runners when changing color. I tried everything but still the rejected products number is high.
best regards
If so, I don't think it is hydraulic issue. try to reload the software that may help
by changing protect setpoint, speed and pressure is there any change in issue?
It was required to raise temperature too much to find out a difference the wave marks became less but the color more became more dark. I think material has been little bit burned
now barrel...
we are using pre colored polypropylene for metallic color so there is no chance for color to be poorly distributed. I tried to raise the mold temperature but no difference.
we have this problem...
hello,
we are always having flow marks on the surface of product when we mold metallic color products. we have tried everything to eliminate it but could't.
material is PP ( pre colored)
any...
thank you for your reply
there is no sink mark on the product, it is just like a white line around the product in the middle
I thought that it is from the changing of flow direction inside the...
Thank you for your reply
We have tried to get rid of this line mark on the surface of product but we couldn't we have tried with injection speed but no change.
what do you think?
material: PP
thickness: 4,5 mm
cold...
we have used material with MFI 40. problem 100% solved
thank you all
thank you for your reply
I am using polypropylene material with MFI = 20
mold is hot runner
somebody suggested to increase the diameter of gate
what do you think?
hello,
how can I get rid of the wave marks on the product surface?
photo is attached
thanks and best regards
we have dosing controller on all machines but we are using it to add softening materiel. I don't think my boss is ready to buy gravimetric blender for all machines.
thank you for your reply
I couldn't understand how can purging compounds be helpful in this issue.
hello everyone,
we are using recycled polypropylene to mold trash can, we have problem with color that while molding product, color the going to be more light that is because of the specific gravity...