Search:

Type: Posts; User: bbevc; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    3,216

    Re: New Technology For Injection Molding

    you can try with apc systems- process control and adjustment (adaptation) from shot to shot. i know that krauss maffei has apc, other manufacturers has probably diferent names for this system.
  2. Replies
    15
    Views
    5,442

    Re: Injection End Position Error

    hello!
    maybe cushion comes to 0? i dont know this type of machine. i see you using time to switchover on holding pressure, try to exchange this with way (mm).
  3. Replies
    3
    Views
    4,587

    Re: more krauss issues

    hello!
    im guessing that you have old machine, aprox 15 years, with mc3 control?
    You must put 1 on hand zero positions. In this mode the pump will have reduced pressure and speed. If you have used...
  4. Replies
    4
    Views
    5,373

    Re: krauss alarm help

    here, check cables in connector or outside of him, and check these fuses- shold be 2 or 4 A!281282
  5. Replies
    4
    Views
    5,373

    Re: krauss alarm help

    hello!
    Have you check connections on ejector/core pulling connector? If you use ejector switch with controling it on the machine and create short cut, it gives you alarm and the screen becomes...
  6. Replies
    13
    Views
    105,904

    Re: Living hinge advice

    Hello!
    If the part is too long, try reduce cooling time. i had same problem on similar tool, and i had to reduce cycle time for almost half, from 50s to 33 s. open the mold as soon it is possible,...
  7. Replies
    3
    Views
    101,914

    Re: Fiber orientation.

    Only speed can save you. Or try with gb material if it is possible. I had a problem because the part was visible and on my luck customer was satisfyed with gb material. Or try with some mineral...
  8. Replies
    6
    Views
    2,306

    Re: noise at start of opening phase

    Hi! Does that happened now, or is it noise from begining, when machine was new? At hydraulic systems i never know, is it noise, should be noise, or should be silence :) on a couple our machines we...
  9. Replies
    5
    Views
    8,750

    Re: Heater Band Overheating HELP!

    Hi! I dont know how it goes on sumitomo, but at krauss maffei we have to optimise heaters. Machine does that by herself, you just have to run this optimisation and then she measure power and...
  10. Re: Krauss Maffei, Battenfeld, user manual, documentation, electronic schemes

    Hello! Im guesing that krauss maffei has mc3 controller? If you still need, i have documentation for krauss 94 mc3.
Results 1 to 10 of 10