Van Dorn 230 HT Ejector Speed
I am having trouble figuring out my ejector system, they are moving forward and retracting at lightning speed. I have already set forward to .25in/s and 100psi, retract is at 0in/s 0psi. no luck. it sounds like the ejectors are going to come out the back of the mold its so bad. any ideas to correct this?
Re: Van Dorn 230 HT Ejector Speed
Does the mold have springs?
Do you have the ejector tied in? Or are they just push?
-Suhas
Re: Van Dorn 230 HT Ejector Speed
The ejectors are tied in, I don’t think the mold has springs
Re: Van Dorn 230 HT Ejector Speed
Is the Ejector Transducer working, make sure it is linear.
Re: Van Dorn 230 HT Ejector Speed
Transducer is working, I measured the voltage on it
Re: Van Dorn 230 HT Ejector Speed
do we have hydraulic prints ? I would look at the valve that controls it next, not familiar with VD but there may be a flow control valve in the ejector valve stack.