Printable View
I am having trouble figuring out my ejector system, they are moving forward and retracting at lightning speed. I have already set forward to .25in/s and 100psi, retract is at 0in/s 0psi. no luck. it sounds like the ejectors are going to come out the back of the mold its so bad. any ideas to correct this?
Does the mold have springs?
Do you have the ejector tied in? Or are they just push?
-Suhas
The ejectors are tied in, I don’t think the mold has springs
Is the Ejector Transducer working, make sure it is linear.
Transducer is working, I measured the voltage on it
do we have hydraulic prints ? I would look at the valve that controls it next, not familiar with VD but there may be a flow control valve in the ejector valve stack.