Hot-Runner/Mold Cable Configuration Standard

Hi All,

Anyone know of a known ISO, ASTM or some other standard for Hot-Runner/Mold Cable configuration?

We have an internal standard generally 24 pin 12 zone Han B connections, keeping power and thermocouple cables separate. Then double latch mainframe side and single latch mold side.

Been searching for a bit and haven't found much for general standards, everyone does it a little differently. Thought I'd start a thread here for discussion

Any ideas?

Thanks,

Chris

I would look through the DME catalog, i can't seem to link the catalog on here, but it list all the configurations i have seen.