I have a vt 110 that the linear transducer for the injection is only reading 0.00 to 0.04 wont go any higher. Tried a known good one from a working machine. Still the same 0.00 to 0.04 any ideas on what could be wrong.
Printable View
I have a vt 110 that the linear transducer for the injection is only reading 0.00 to 0.04 wont go any higher. Tried a known good one from a working machine. Still the same 0.00 to 0.04 any ideas on what could be wrong.
Input card reading the position from transducer.
i would test the wiring first, unless you have a spare dsp board in storage. Also make sure you have the MCL and the screenware ready, its always a roll of the dice when you power it down for any reason.
what controller is on the Machine?
May be the input number is wrong.