moldingppm
15th December 2017, 07:38 PM
Hey guys,
Recently purchased a used Nissei press.
Upon putting the first mold in, I've found that most, if not all threads are either tight or stripped out. I was thinking using those thread repair inserts, but wasn't sure how good they were for holding molds/clamps.
Anyone have any suggestions?
Recently purchased a used Nissei press.
Upon putting the first mold in, I've found that most, if not all threads are either tight or stripped out. I was thinking using those thread repair inserts, but wasn't sure how good they were for holding molds/clamps.
Anyone have any suggestions?