Patric
29th October 2017, 11:59 PM
Hi All,
I just received a Cincinnati VT 165 Ton injection molding machine and I'm trying to do the set up for a new mold. I would like to know how I can reset the "Actual Clamp Position" because it seems to be off. When the mold is in the machine and the clamp is closed the value for the Actual Clamp Position is not zero and have a value of 0.82 in. The machine runs well in manual mode, but when I try to run a single cycle an error message pup up.
I would appreciate any advice on how to reset the Actual Clamp Position in this types of machines
Thanks,
Patric
I just received a Cincinnati VT 165 Ton injection molding machine and I'm trying to do the set up for a new mold. I would like to know how I can reset the "Actual Clamp Position" because it seems to be off. When the mold is in the machine and the clamp is closed the value for the Actual Clamp Position is not zero and have a value of 0.82 in. The machine runs well in manual mode, but when I try to run a single cycle an error message pup up.
I would appreciate any advice on how to reset the Actual Clamp Position in this types of machines
Thanks,
Patric