William Wonkum
1st November 2016, 03:31 PM
Hello, I'm new to this forum and new to injection molding in general. I had a question about this type of product in this image:
153
What would the mold for this look like? I'm just trying to get my head around it, how the different mold parts would pull off. It is "hollow", it lets water pass through, acting as an adapter for two pipes, providing a female threaded connection at one end, and a male threaded connection at the other. Any images you can send of molds or sketches or diagrams will be greatly helpful. Thank you.
Link to the image, if it doesn't load:
http://imgur.com/yuuJdHl
153
What would the mold for this look like? I'm just trying to get my head around it, how the different mold parts would pull off. It is "hollow", it lets water pass through, acting as an adapter for two pipes, providing a female threaded connection at one end, and a male threaded connection at the other. Any images you can send of molds or sketches or diagrams will be greatly helpful. Thank you.
Link to the image, if it doesn't load:
http://imgur.com/yuuJdHl