View Full Version : Mold Coating effectivness
Monomer
6th July 2016, 05:06 PM
We currently have a few molds that run in semi-auto and require a full operator to run the press. The operator needs to spray the mold every cycle so the parts release.
Has anyone had success with mold coatings to help parts release from the mold easier?
We run these molds in glass filled PC.
brentb
7th July 2016, 01:23 PM
Coatings can really solve problems. Contact Bales for the correct coating for your application:
http://www.balesusa.com/coatings/
KOM
brent
Josue
8th July 2016, 06:04 PM
I already work With Bales, they do a good work here in Tx area
we apply nibore coat in a PC+GF with good results, however in some molds due to the design you most set a mechanical eject block to help to eject or detach the parts from fixed /moving side of the molds, some times its not enough with release coating
best regards
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.