miuraj10
17th February 2016, 06:46 PM
Hi Guys,
Another question for you. the proposed location for adding some ribs would be directly opposite of the gate location. See the picture. If the plastic is injected directly into the rib, (from the opposite wall) are their any major concerns with doing this? The wall is 3mm the gate is a pin point 2.5mm gate. the ribs run the length of the part and are 2mm wide by 4.5mm high. 130
Another question for you. the proposed location for adding some ribs would be directly opposite of the gate location. See the picture. If the plastic is injected directly into the rib, (from the opposite wall) are their any major concerns with doing this? The wall is 3mm the gate is a pin point 2.5mm gate. the ribs run the length of the part and are 2mm wide by 4.5mm high. 130