View Full Version : How to Optimize Pack & Hold Times for Hot-Runner & Valve-Gated Molds
Suhas
9th November 2015, 08:05 PM
Hello All,
FYI ... in this this month's magazine:
http://www.ptonline.com/articles/how-to-optimize-pack-hold-times-for-hot-runner-valve-gated-molds
Regards,
Suhas
Ten Fingers
11th November 2015, 06:09 AM
Nice to see it on ptonline! Sharing this knowledge is great, but it is making dedicated readers of this forum less valuable :<)
Suhas
11th November 2015, 09:37 PM
Thanks Ten Fingers.
I think you guys are very valuable to me! I am hoping that the PTOnline will attract more people here.
Thanks for your contributions!
Suhas
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.