View Full Version : Venting on Stat side or Moving side
nicholas
3rd February 2015, 06:48 PM
Pretty simple question -- are there advantages or disadvantages to using surface venting on one side or the other?
brentb
3rd February 2015, 07:44 PM
No no no no no no no
KOM
brent
nicholas
3rd February 2015, 10:05 PM
No no no no no no no
KOM
brent
That was pretty straightforward. Thanks!
Suhas
4th February 2015, 12:19 AM
You can add one more 'No' from my side :)
Just make sure you have a LOT of venting. There can never be too much venting. Of course, vent depths are important; you can have have too much vent depth that will show up as flash.
Suhas
Jendalf
4th February 2015, 11:04 AM
Hi,
of course there are! But they come out when your question will be more specific and you will start to speak about venting for certain tool and design.
Generally, no :)
J.
brentb
4th February 2015, 01:58 PM
You have to have a minimum amount of characters in a post here!
KOM
brent
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.