Mold advice and/or consultancy needed

[Ronald Carter]

I am looking for someone that can make the needed changes to my CAD designs in order to make them ready for the fabrication of a mold, as well as advise me if I am going in the right direction as far as materials and assembly methodology is concerned.

I have the design done, but for me to come up to speed on bosses, drafts and core pins, etc. would be tough. Any help and/or recommendations for a consultant would be most appreciated.

Thanks! Ron

[Suhas]

Hi Ron,
What geographical area are you located in?
Are you talking about par design or mold design or both.
Let us know. I know a few people who may be able to help. you can send me an email also - suhas@fimmtech.com.
Suhas