View Full Version : Hold end Pos
Josue
26th June 2014, 09:17 PM
Whats the relation or rule or consideration between transfer position and Hold end pos in a injection process?
I check this in a sumitomo screen
brentb
27th June 2014, 07:51 PM
Probably akin to cushion and actual cushion on a Toshiba. If you have enough pack and hold pressure you can have an ending screw position "smaller" than what you transferred at
What sayeth you Suhas?
KOM
brent
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.