Injection molding of below shown part

[s_pme20]

We need to manufacture attached image part by injection molding. Can anyone please suggest is it manufacturable or nor..challenges, suggestions, alternate method?
Material: Ticona Vectra 540i, 1.5mm thick
Qty: < 150/ year
Rough dwg, dim. in mm

[Suhas]

Hi,
Injection Molding for less than 150 parts a year will be very expensive - mainly because of cost of mold and machine time. It is also thick for molding. Not sure from the drawing about the mini-features you need. You may try to go to a a composites manufacturer - wild guess here. I have been reading a lot about 3-D printing. Think out of the box and may be you have the answer!
Suhas

[rickbatey]

For that volume they should find another method. Isn't that resin an LCP?
Rick.

[s_pme20]

Thank you for suggestions....Basically this part is going to be used in high temp. environment (Up to 250 degree C)..Material is Ticona Vectra 540i


What alternate menthods for manuifacturing exists...sorry I am new to plastic world!

[Suhas]

You may get the best answer from the Ticona people or from the literature of the material. Sorry, not trying to blow you off.
Suhas