Rohit876
1st July 2013, 05:01 PM
Hi Everyone,
Another problem with a different Chinese Injection molding machine. This one is 360 ton machine from Ningbo Hengrun and is used to make single cavity 740 gramm preform. The problem is as follows:
1. Noisy hydromotor while charging specially the drain pipe.
2. Oil and grease coming out of the point where grease is inserted for the lubrication of the bearing responsible for movement of screw.
3. Rotation of the screw clockwise during injection. Although the speed and frequency is not much.
I can share videos and pictures in case anyone wants to see and gives me his / her mail id.
Thanks for reading and help.
Regards.
Another problem with a different Chinese Injection molding machine. This one is 360 ton machine from Ningbo Hengrun and is used to make single cavity 740 gramm preform. The problem is as follows:
1. Noisy hydromotor while charging specially the drain pipe.
2. Oil and grease coming out of the point where grease is inserted for the lubrication of the bearing responsible for movement of screw.
3. Rotation of the screw clockwise during injection. Although the speed and frequency is not much.
I can share videos and pictures in case anyone wants to see and gives me his / her mail id.
Thanks for reading and help.
Regards.