moldingppm
21st March 2013, 02:35 AM
Hey guys,
I'm running a 16 cavity mold right now that uses sub-gates for the gating. The problem I'm encountering is probably every 10-20 shots, I get a gate that gets clogged with material (so it either shorts or doesn't make a part). Does anyone have any tips on how to reduce this issue? I know it's not contamination, as I've been running the same job/material for the last 2 years out of this machine. Just stumped.
I'm running a 16 cavity mold right now that uses sub-gates for the gating. The problem I'm encountering is probably every 10-20 shots, I get a gate that gets clogged with material (so it either shorts or doesn't make a part). Does anyone have any tips on how to reduce this issue? I know it's not contamination, as I've been running the same job/material for the last 2 years out of this machine. Just stumped.