processtech
10th September 2012, 10:34 PM
Hello all,im relatively new to the area of injection moulding,
I am wondering has any of you on here any information regarding the calibration of colortronic dosing units. I have succesfully calibrated the Colortronic Colorblend unit with the c150 micro processor,but am unsure of the procedure of calibrating the microblend and CSE 2 units, rather than a calibration procedure,is it more a case of adjusting the settings until the desired amount of masterbatch is dispensed? For the colorblend unit i calculated the dosing time and the masterbatch weight, i then entered the dosing time and adjusted the motor speed to dispense the masterbatch quantity required. Is this the correct procedure?
Also the CSE 2 unit set up procedure.
Regards, Processtech
I am wondering has any of you on here any information regarding the calibration of colortronic dosing units. I have succesfully calibrated the Colortronic Colorblend unit with the c150 micro processor,but am unsure of the procedure of calibrating the microblend and CSE 2 units, rather than a calibration procedure,is it more a case of adjusting the settings until the desired amount of masterbatch is dispensed? For the colorblend unit i calculated the dosing time and the masterbatch weight, i then entered the dosing time and adjusted the motor speed to dispense the masterbatch quantity required. Is this the correct procedure?
Also the CSE 2 unit set up procedure.
Regards, Processtech