PDA

View Full Version : 2 cubic inch capacity



gwfami
30th June 2012, 03:37 AM
Hi,
I'm in need of a small injection molding machine that has a shot capacity of 2 cubic inches and a mold size of 6 inches by 6 inches by 2 inches for our startup business. Anyone have any suggestions? We are on a tight budget, so the less expensive the better.

Thanks,

GWFAMI

Suhas
1st July 2012, 04:12 PM
Hi,
Depending on the accuracy you are looking for and I am assuming that you are looking for a used one, I would suggest a Nissei micromolding machine or a Sumitomo. Lately the BabyPlast has also gained some ground: http://www.babyplast.net/babyplast610.asp
Where are you located?
Reards,
Suhas

gwfami
1st July 2012, 04:42 PM
Hi,
Thanks for the reply. I'm located in Kansas, USA.