collij3
7th March 2019, 06:50 PM
In manual, setup and auto-cycle modes;
clamp close motion is good until reaches mold protect set point and then clamp stops few seconds then continues to close then stops again and continues to close and so-on till mold touch and builds tonnage to preset tonnage.
Open motion is good without issues.
There are no alarms or faults on panel screen and cycle does not interrupt or stop during intermittent stops while in close motion
Maintenance attempts for resolution not successful.
Verified pump manifold valves GG1, GG2, and clamp manifold valves.
Baffled but not surrendering, Suggestions welcome.
clamp close motion is good until reaches mold protect set point and then clamp stops few seconds then continues to close then stops again and continues to close and so-on till mold touch and builds tonnage to preset tonnage.
Open motion is good without issues.
There are no alarms or faults on panel screen and cycle does not interrupt or stop during intermittent stops while in close motion
Maintenance attempts for resolution not successful.
Verified pump manifold valves GG1, GG2, and clamp manifold valves.
Baffled but not surrendering, Suggestions welcome.